Network Heavy Duty Power Switch
- Two Individual Switched Outlets
- Dual 20-Amp circuits
- Integrated 10-BaseT Interface
- RS-232 Modem and Console Ports
- Outlet-Specific Password Security
- Network Security Features
- Power-up Sequencing
- User-Level and Administrator-Level Access
- Modem Auto-Setup Command Strings
- Telnet or Terminal Emulation Software Controlled
Network equipment sometimes "locks-up" requiring a service
call to a remote site just to flip the power switch to perform a simple
reboot. The NPS-2HD Heavy Duty Network Power Switch gives network administrators
the ability to perform this function from anywhere on the LAN/WAN,
if the network is down, to simply dial-in from a standard external modem
for out-of-band power control.
The NPS-2HD can be controlled over any TCP/IP network using generic Telnet,
or out-of-band by using an external modem and basic VT100 type terminal
emulation. Each independent outlet can be switched ON, OFF or Booted (OFF-
delay-ON). Each outlet can also be assigned an individual password, device
name, reboot delay time and unique power-up default state.
and Co-Location Features
The NPS-2HD unit employs address-specific IP security authorization to
prevent unauthorized sources from entering the NPS command mode. Two levels
of operational passwords are also available; the system administrator
level, and individual user level. The user-level security features are
ideal for co-location applications where multiple users may be allowed
plug-specific access to the NPS-2HD unit.
Dual Power Bus
The NPS-2HD is equipped with two separate 20 Amp power circuits.
Each bus has it's own source AC inlet, circuit breaker and one switched
outlet. This allows for switching redundant A/B power supplies or switching
devices with high current requirements.