CPS » Remote Reboot Switches AC Power Control » SP-RRC

SINGLE PORT REMOTE REBOOT CONTROLLER (SP-RRC)

Provides Remote Reset Control and Shares the Phone Line

 

 

SP-RRC
SP-RRC Picture
  • Share with Normal Phone/FAX Line Usage
  • AC Power or Reset Button Reboots
  • Remote Maintenance Applications
  • AC Power On/Off Control Too
  • Remote Programming

 

 

SAMPLE BASE UNITS
ARR Picture

Intelligent AC Power Strip

PC-RJ Cable Interface Assembly Picture

PC-RJ Cable Interface Assembly

  More Remote Reboot AC Power Control Products...

APPLICATION DIAGRAM

SP-RRC Application Diagram


DESCRIPTION

  • Touch-Tone Password Up To Six Digits
  • Touch-Tone Control Commands
  • Very Easy To Use
  • Cable Distances Up To 2000' or Rack Mount

Introduction
The SINGLE PORT REMOTE REBOOT CONTROLLER (SP-RRC) is an out-of-band reset (dial-line) controller that is primarily used to reset equipment remotely or locally through a series of touch-tone commands.

The SP-RRC can be installed on any analog dial line and can share the line with other normal voice, modem, fax or PBX requirements. The shared Default Port supports the phone equipment and a Reset device simultaneously, if required.

It can also be used as a security device by simply using it to turn the remote equipment, such as a modem, ON or OFF.

Note that the SP-RRC is a controller only. It has one RJ-11 port and requires a CPS Base Unit (such as an Intelligent AC Power Strip or an RJ-Cable Assembly). They are connected to the SP-RRC via the RJ-11 connector. They can be physically located locally or up to 2000' from the controller, using standard phone or LAN cable.

The Intelligent AC Power Strip is normally used when the target machine does not have a reset button or when direct power ON/OFF control is also required. It has six AC outlets: two (2x4), four (4x2), or all six (6x0) may be designated as "Controlled Outlets" at the time of the order. The others may be used as normal surge protected AC outlets for printers, monitors or other equipment that do not require resets or On/Off control.

The RJ-Cable Assembly allows the SP-RRC to perform a push-button reset (soft reset) on a PC. To use it, the target machine must have a Reset button that connects to the motherboard. It installs in a vacant I/O opening on the back of the machine's case, but does not require a slot on the motherboard. The connecting cables allow the Reset button to also be used normally.

ATX Motherboards
The BIOS on ATX motherboards normally has several options to deal with the loss of AC power: to power-up only after the momentary Power Button is pressed (default), to return to its previous state before the AC power was lost, or to power-up when the AC power is restored. This last option allows the systems to be used with the Intelligent AC Power Strip for direct AC power control.

However, these motherboards can also be used with the Auto Push Board (APB). The APB performs the first option above by pushing the Power Button once AC power returns. (See Resetting ATX Motherboards.)

How to control it
The programmable administrator's touch-tone Configuration Commands and the caller's Access Codes and Control Commands can be entered from any touch-tone telephone pad. They may also be appended to the AT dial command string of a dial modem. The SP-RRC will accept the commands remotely through its Telephone Line Port "TelCo" or the local default Phone Port or both. This provides remote dial control or local control over the building wiring or both. The commands are stored in EEPROM in the event of a power failure.

 

A typical touch-tone command may be:
(phone #) (access code & port #) (on/off/reset)

How it works
When a call is received, the SP-RRC either answers the call immediately or passes the rings through to the default port allowing something else to answer first. In either event it listens for a Command to begin for xx time and takes the appropriate action if it hears it. If a Command is not heard, the call may be aborted (Secure Mode) or passed to the Default Port (Shared Mode).

Three Port & Eight Port models are also available.


SPECIFICATIONS

SINGLE PORT REMOTE REBOOT CONTROLLER (SP-RRC)
Item No SWTSPRRC            Price Contact Bomara 

Also Available
Item No SWT3PRRC (3 Port)   Price Contact Bomara
Item No SWTMPRRC (8 Ports)  Price Contact Bomara 

Physical    4.5" W x 3" D x 1.25" H, 1 lb.
Connectors  (2) RJ-11 TelCo
LEDs        (3) Power, Mode
Switches    (1) 4-Bit Dip, (1) Pushbutton
Bell        None
Cable       (1) 5' RJ-11 Phone Cable
Adaptor     None
AC Power    Wall Mount 9VAC 1A, 115V/60Hz

NOTE: For 220V/50Hz, add (-INT) to the Item No


------ NON-ADDRESSABLE BASE UNITS ------

OPTIONAL INTELLIGENT AC POWER STRIP
2 Controlled and 4 "Normal" Outlets
Item No SWTAC6-A2-2x4       Price Contact Bomara

4 Controlled and 2 "Normal" Outlets
Item No SWTAC6-A2-4x2       Price Contact Bomara

6 Controlled Outlets
Item No SWTAC6-A2-6x0       Price Contact Bomara

Physical    12" W x 2.5" D x 1.5" H, 2 lbs.
Connectors  (2) RJ-11 TelCo/Control,
            (6) AC Receptacles
LEDs        (1) Surge Protection
Switches    (1) Main Toggle On/Off
Bell        None
Cable       (1) 5' RJ-11 Phone Cable
Adaptor     None
AC Power    115V/60Hz, 15 Amps

NOTE: For 220V/50Hz, see the IPC.


OPTIONAL INTERNATIONAL POWER CONTROLLER (IPC)
See the IPC


OPTIONAL PC-RJ CABLE INTERFACE ASSEMBLY
Item No CAPC2-RJ            Price Contact Bomara

Physical    5.5" W x 2.5" D x .75" H, .25 lbs.
Connectors  (1) RJ-11 Interface,
            (4) PC Headers Pins
LEDs        None
Switches    None
Bell        None
Cable       (1) 2' M/F Reset Switch Cable,
            (1) 2' F/F Motherboard Reset Cable,
            (1) 5' RJ-11 Cable
Adaptor     None
AC Power    None


OPTIONAL RELAY BOX
See the Relay Box


-------- ADDRESSABLE BASE UNITS --------

OPTIONAL A/B, MATRIX or X2 SWITCH
See the AB-M


OPTIONAL INTELLIGENT AUTO PUSH BOARD (I-APB)
See the APB


OPTIONAL INTELLIGENT POWER NODE (IPN)
See the IPN
      



Call Us: 1-978-452-2299
First Name:
Last Name:
Company:
Address:
Mail Stop:
City:
State (if in US):
Province/Region (if outside US):
Country:
ZIP (Postal) Code:
E-mail:
Telephone:
Fax:
Questions/Comments:
Verification: Please type:
Please have a Bomara Associates representative contact me


View Full Site View Mobile Optimized