Powerware 9330 - Powerware (Eaton)

Powerware 9330

Specification Details

Electrical Input
Input Voltage	120/208 VAC, 3 phase + GND (rectifier) 120/208 VAC, 3 phase + N + GND (Bypass)
Voltage Range	-15%, +10%
Frequency	50/60 Hz
Frequency Range	45 - 65 Hz
Input Power Factor	> 0.96, Typical
Surge Protection	Meets IEEE 587, Category A & B and EN 50091-2
Electrical Output
Output Voltage	120/208
Voltage Regulation	Static: better than ±1% Dynamic: better than Figure one of EN50091-3 (IEC 62040-3)
Voltage Distortion	Less than 3% for 100% linear load Less than 5% for nonlinear load when tested in accordance with EN50091-3
Frequency Regulation	Synchronization: ±0.5, ±1.0, ±2.0 Hz, selectable Free-running: ±0.005 Hz Slew rate: 0.5, 1.0, 2.0, 3.0 Hz / sec, max selectable
Over Current	101 - 110% for 10 min (inverter) 111 - 125% for 1 min (inverter) 126 - 150% for 30 sec (inverter)
Environmental
Ambient Temperature	Operation 0 to + 40ºC (32 to 104ºF) Storage -20 to 70ºC (-4 to 140ºF)
Relative Humidity	95% maximum, non-condensing
Altitude	1500 meters (5000ft) at 40ºC ambient without load derating
Audible noise	Less than 55dBA typical at 1 meter; in accordance with ISO 7779
Electrostatic Discharge	Withstands 25kV without damage or disturbance to the load; exceeds requirements of IEC 801-2
EMC	Meets FCC Class A and EN50091-2 (IEC 62040-2)
Safety
	UL1778 CUL CAN/CSA C22.2 NO.107.1 EN 50091-1
Mechanical
Cable Entry	Bottom rear, Bottom front
Cooling	Filtered forced air with redundant fans
Access	Front and top only required for service
Communications
Serial Port	RS-232 communications port standard
Service Port	RS-232 for service of equipment by qualified service personnel standard
Communication Cards	up to four optional cards can be installed in the UPS module at any time and provide the following connectivity: – single RS-232 port – multiple RS-232 ports – Ethernet Interface – SNMP Adapter – Modem Driver
Remote Communications	Four input building alarm contacts Two summary alarm contacts
Relay Interface Module	Optional– provides five relay contacts

Model Selection Guide

POWERWARE 9330-20 PERFORMANCE CHARACTERISTICS	MODEL 10 10KVA/7KW					MODEL 15 15KVA/10.5KW					MODEL 20 20KVA/14KW
Input Voltage -Volts	208	480	480	600	400	208	480	480	600	400	208	480	480	600	400
Output Voltage -Volts	208	208	480	208	400	208	208	480	208	400	208	208	480	208	400
Input/output Frequency -Hz	50/60	60	60	60	50	50/60	60	60	60	50	50/60	60	60	60	50
Input Voltage Range
Minimum Volts	177	408	408	510	340	177	408	408	510	340	177	408	408	510	340
Maximum Volts	239	552	552	690	460	239	552	552	690	460	239	552	552	690	480
AC Input (With input filter)
Nominal Amps	22	10	10	8	12	32	14	15	11	18	43	19	20	15	23
Maximum Amps	29	30	13	30	16	40	41	18	41	22	51	52	23	52	28
AC Input (Without input filter)
Nominal Amps	22	10	10	8	12	32	15	15	12	18	44	19	20	16	24
Maximum Amps	30	13	14	11	16	41	18	19	14	22	52	23	23	18	28
Bypass Input
Nominal Amps	28	12	12	10	14	42	18	18	14	22	56	24	24	19	29
AC Output
Nominal Amps	28	28	12	28	14	42	42	18	42	22	56	56	24	56	29
10 Minutes	35	35	15	35	18	52	52	23	52	27	69	69	30	69	36
Battery
Nominal Voltage -Volts	288	288	288	288	288	288	288	288	288	288	288	288	288	288	288
Charge Voltage @ 25ºC -Volts	366	366	366	366	366	366	366	366	366	366	366	366	366	366	366
Charge Current -Amps	7	7	7	7	7	7	7	7	7	7	7	7	7	7	7
Nominal Discharge Current -Amps	27	28	29	28	29	41	42	43	42	43	55	56	57	56	57
Total Cell Count	144	144	144	144	144	144	144	144	144	144	144	144	144	144	144
System Efficiency
@100%Load	91%	88%	86%	86%	86%	92%	89%	87%	87%	87%	92%	90%	88%	90%	88%
@75%Load	90%	87%	85%	85%	85%	92%	89%	86%	86%	86%	92%	90%	88%	90%	88%
@50%Load	88%	85%	83%	83%	83%	91%	88%	85%	85%	85%	92%	90%	88%	90%	88%
Max. Heat Dissipation
BTU/Hr.(x1000)	3.3	4.2	4.8	4.8	4.8	4.1	5.4	6.3	6.3	6.3	5.1	6.3	7.5	6.3	7.5
kcal/Hr.(x1000)	0.8	1.1	1.2	1.2	1.2	1.0	1.4	1.6	1.6	1.6	1.3	1.6	1.9	1.6	1.9
Inverter Efficiency (Full Load) -%	93%	93%	90%	90%	90%	94%	94%	92%	92%	92%	94%	92%	90%	92%	90%
Physical Attributes (max.)
Width	22	39	39	39	39	22	39	39	39	39	22	39	39	39	39
1 Efficiency shown takes into account the output transformer for output voltages other than 208V.

2 All accessories feature plug and play capability.
Shipping pallet and packaging adds 50 lbs. per shipping unit.

3 Options cabinet is required for voltages other than
208/208 V In/Out.

UPS Battery Run Times (in minutes)

	Run time at			Installed
	10kVa 7kVa	15kVa 10.5kVa	20kVa 14kVa	Weight (lbs)	Width (inches)
Internal Battery	35	20	12	-	-
1 external battery cabinet	95	50	35	600	17
2 external battery cabinets	150	95	60	1200	34
3 external battery cabinets	200	130	95	1800	51
4 external battery cabinets	260	165	120	2400	68
5 external battery cabinets	320	215	150	3000	85