TPC8 Series:

TPC8-A

TPC 2234 chassis eng and wiring diagram show 15A reset breaker, lighted on/off rocker switch, 9' 14/3 cable with 5-15 plug.

TPC8-A-1063

TPC 115-8-A with 12/3 gauge cable and L5-20, Filter and MOVs included.

TPC8-A-1093

Standard TPC 115-8-A except one of the duplexes on the rear panel is a L5-15 duplex.

TPC8-A-1214

Based on TPC 115-8-A-951 (standard TPC 115-8-A but black chassis) but modified to have a 15' power cable and no filter.

TPC8-A-1215

Based on TPC 115-8-A-951 (standard TPC 115-8-A but painted black) but modified to have a 15' power cable.

TPC8-A-1216

Based on TPC 115-8-A-951 (standard TPC 115-8-A but painted black) but modified to have no filter. All else remains as is standard.

TPC8-A-1256

Standard TPC 115-8-A but modified to have a 15' power cable and a 28v AC low voltage remote on the front panel.

TPC8-A-1404

Power cord is 6' in length instead of standard 9' and is terminated with an L5-15P plug instead of standard 5-15P.

TPC8-A-1515

Power cord is 6' in length instead of standard 9' and is terminated with an L5-15P plug instead of standard 5-15P.

TPC8-A-1646

Standard TPC 115-8-A but with a filter.

TPC8-A-1838

Similar to TPC 115-8-C-830 (10) outlets8 on rear/2 on front except two outlets on rear are wired HOT or unswitched.

TPC8-A-1920

TPC 115-8-A-830 (10) 5-15 outlets but two rear outlets are wired HOT - "Unswitched."

TPC8-A-1940

Standard TPC 115-8-A but with hospital grade outlets and no circuit breaker. BOM exists but could not find drawings.

TPC8-A-1970

Standard TPC 115-8-A but with L5-15P Plug instead of standard 5-15P plug.

TPC8-A-2076

Has a circuit breaker that allows the system to be 400Hz instead of 50/60Hz, also uses (8) L1-15R outlets which the -1768 used standard 5-15R's.

TPC8-A-2129

Standard TPC 115-8-A but no power cord and only four outlets. Cover plates used for other openings.

TPC8-A-2144

Standard TPC 115-8-A but painted Fed.Std. 595 36231 Gray.

TPC8-A-2155

TPC 115-8-A with L5-15R outlets and L5-15P plug at end of cord.

TPC8-A-2285

Standard TPC 115-8-A but painted per client supplied paint chip Cardinal 6402-73783 smooth finish.

TPC8-A-2500

Standard TPC 115-8-A w/ filter & MOVs but the plug is changed to a NEMA L5-20P instead of 5-15P & circuit breaker kick guard is attached.

TPC8-A-3042

TPC 115-8-A with a MIL MS3456W16-10P plug and MIL M85049/52-1-16W strain relief for plug connection to cable.

TPC8-A-3055

TPC 115-8-A modified no filter or MOV's. Front outlets are unswitched & controlled on/off by lighted rocker switch even though main breaker is off.

TPC8-A-602

Standard TPC 115-8-A but with a 15amp Circuit Breaker instead of 20amp. Note that we did drop the "115" from the part number.

TPC8-A-F

TPC 2234 chassis drawing shows what is described above but wiring diagram shows 5-15R w/ 15A reset breaker and lighted rocker switch. 

TPC8-A2-2537

Standard TPC 115-8-A except upgraded to 20A system (A2). Front panel and circuit breaker kick guard 001-2117 painted black.

TPC8-A2-3085

TPC 115-8-A2 but modified to have a 15' cable instead of a 9' cable and terminated with a L5-20P instead of a 5-20P

TPC8-A2-4016

TPC 115-8-A2 modified to have a 15' cable instead of 9" terminated w/ a L5-20P instead of a 5-20P with an attached 3' 12AWG green ground wire

TPC8-ARL-1616

Standard TPC 115-8-ARL but with one 30amp fuse backing up the circuit breaker.

TPC8-ARL-1944

TPC 115-8-ARL but with the light wired to illuminate when the remote is activated to turn power on to switched outlets.

TPC8-ARL-1954

TPC 115-8-ARL but the one remote is wired to be latching & low voltage.

TPC8-ARL-2458

TPC 8-ARL-1954 modified to 120v/20amp with either 9' 3x4mm harmonized cable or 12/3 - 5-20P, UL/CSA/VDE breaker, filter.

TPC8-ARL-4010

TPC 115-8-ARL Assy. 1288 modified to have 1 duplex on rear panel controlled by remote port, all together outlets are un-switched.

TPC8-B

TPC 2234 chassis with one of two cable inputs removed and hole covered.

TPC8-B-1142

TPC 115-8-B but without MOV's and filter. It does have a 6-15 plug.

TPC8-B-1442

TPC 115-8-B but with 15' length cable instead of 9' and terminated with a L6-15 plug instead of no plug.

TPC8-B-1495

Standard TPC 115-8-B but with 12/3 cable and L6-20P plug. Becomes a 20amp input system with 16amp output.

TPC8-B-2025

TPC 115-8-B with 28vAC remote port, 15' cable and no plug.

TPC8-B-2329

TPC 115-8-B with cover plate over two outlet front panel opening. CB is 20/20, includes filter and MOVs, 14/3awg cable 9' and no plug.

TPC8-B-3056

TPC 115-8-B modified NO filter or MOV's. Front duplex unswitched & controlled on/off by lighted rocker switch even though main breaker is off

TPC8-B-F

TPC 2234 chassis with one of two cables removed and opening covered. W2278A exists but no engineering drawing or BOM found.

TPC8-C-1146

Standard TPC 115-8-C but with one of the duplex's in the rear panel being a L5-15R.

TPC8-C-1306

Standard TPC 115-8-C but with 14awg steel instead of standard 16awg.

TPC8-C-1334

Standard TPC 115-8-C but painted Cardinal 6442-6812 (Hewlett Packard Gray).

TPC8-C-1463

Standard TPC 115-8-C but without filter and cable is 10' in length instead of the standard 15'. 

TPC8-C-1469

TPC 115-8-C but with the front duplex removed and covered with metal plate. 

TPC8-C-1526

Uses chassis from TPC 115-8-C-370 (001-0370), CB is Heinemann, no filter, no front duplex-use cover plate, cable is 9' length. 

TPC8-C-1665

Boeing TPC 115-8-C-370 chassis but with, I assume, 2pole 15amp circuit breaker.

TPC8-C-1722

(4) 5-15 outlets and (2) cover plates used to cover the two other duplex openings. (2) single pole CBs used, one for each of the two duplexes.

TPC8-C-1725

(2) 5-20 outlets on front and (2) on back, (2) duplex cover plates used to cover other openings. MIL style input connector on rear where power cable was

TPC8-C-1740

Uses 001-0370 chassis, cable is 6' with L5-20P, CB kick guard used, (2) 5-20 outlets on front and two cable grips on back for client to hardwire output.