PCP-PoE & TPCP-PoE Series
PowerCassette® PoE Switching Power Supply
for Power over Ethernet Applications
1U High, 48VDC at 1200 Watts with PFC and Hot Swap
>> Pictures and Diagrams
<< Back to Unipower Telecom Home
KEY FEATURES
- Universal 85-264VAC Input
- 1500VAC Output Isolation
- Meets IEEE 802.3af
- 3600W for 3 Units in Rack
- Includes Isolated 5V, ¼A Standby Output
- Hot-Swap or Chassis Mount
- 48VDC at 25A Output
- Integral LED Status Indicators
- I2C Serial Data Bus Option
- 15 Watts per Cubic Inch
- Power Factor Corrected
- Low Profile: 1.6 Inches High
- Single Hot-Swappable Connector
- Staged Pin Engagement
- ORing Diode on Output
- 1U, 19" Rack Holds 3 Units*
- Active Current Sharing
- Class B EMI Input Filter
* TPCP Model |
|
MODULE ORDERING GUIDE
| MODEL NUMBER |
MAX. OUTPUT POWER |
OUTPUT VOLTAGE |
OUTPUT CURRENT |
INPUT VOLTAGE |
PFC |
TYPE |
| TPCP7000-POE |
1200W |
48VDC |
25A |
85-264VAC
|
Yes |
Hot-Swap |
| PCP7000-POE |
1200W |
48VDC |
25A |
85-264VAC
|
Yes |
Chassis Mount |
Note: The table does not show the independent 5V, ¼A standby output which is standard on both models.
RACK ORDERING GUIDE
| MODEL NUMBER |
MAX. MODULES |
MAX. POWER |
MAX. CURRENT |
AC CONNECTION |
RACK DEPTH |
| TPCR1U3A |
3 |
3600W |
150A DC |
Term. Block |
12.66" (322mm) |
| TPCR1U3B |
3 |
3600W |
150A DC |
IEC C20 |
13.15" (334mm) |
| TPCR1U3C |
3 |
3600W |
150A DC |
IEC C20* |
14.88" (378mm) |
* AC line filter included with each AC inlet.
AVAILABLE OPTIONS
| CODE |
OPTION |
Z |
I2C Serial Data Bus |
Note: Add Option Code as suffix to model number. Contact Bomara on availability of Option Z.
TECHNICAL SPECIFICATIONS
Typical at nominal 115/230VAC line, full load and 25°C unless otherwise noted.
OUTPUT
- Max. Total Continuous Output Power: 1200 Watts
- Min. Voltage Adjustment Range: ±5%
- Total Regulation1: 2.0%
- Total Regulation, Standby Supply: 5.0%
- Ripple & Noise, Pk-Pk2: 1%
- Holdup Time: 20ms
- Dynamic Response3: 300μs
- Temperature Coefficient: ±0.02%/°C
- Minimum Load: 0A
- Overload Protection: Auto Recovery
- Overvoltage Protection: Latched Shutdown
- Remote Sense: Up to 0.25V Per Wire
- Current Share: ±10% Full Load Rating
- Standby Output: +5V, 250mA
- DC Power Good Signal: Logic Low
- AC Power Fail Signal: Logic High
- Global Inhibit: Logic Low
- Enable: Logic Low
- Thermal Warning: Logic High
INPUT
- Input Voltage Range: 85-264VAC
- Power Factor: 0.99
- Input Frequency: 47-63Hz
- Inrush Current Limiting: 50A Peak
- Input EMI Filter: EN55022 Curve B, FCC20780 Part 15J Curve B
- Harmonic Distortion: EN61000-3-2
- Input Immunity, Conducted
- Fast Transients, Line-Line: ±2kV (EN61000-4-4 Level 3)
- Surges, Line-Line: ±2kV (EN61000-4-5 Level 3)
- Surges, Line-Ground: ±4kV (EN61000-4-5 Level 4)
- Input Protection: Internal Fuse, 20A
|
GENERAL
- Efficiency: 87% at Full Load
- Switching Frequency
- PFC Converter: 48-110KHz
- Output Converter: 275KHz Nominal
- Min. Isolation, Class I4
- Input-Output: 3000VAC
- Input-Frame Ground: 1500VAC
- Output-Frame Ground: 1500VDC
- MTBF (Bellcore): 200,000 Hours
- Safety Standards: EN60950, UL6091950, CSA22.2 #609950
ENVIRONMENTAL
- Operating Temperature: 0°C to 70°C Ambient
- Derating: 2.5%/°C, 50°C to 70°C
- Storage Temperature: -40°C to 85°C
- Cooling: Integral Ball Bearing Fans
PHYSICAL
- Case Material: Aluminum
- Dimensions: 1.6" H x 5.0" W x 10.0" D (40.6mm x 127mm x 254mm)
- Weight: 3.15 lbs (1.43 kg)
NOTES:
- No load to full load, including line regulation and load regulation.
- 20MHz bandwidth. Measure with 0.1μF ceramic and 10μF tantalum capacitors in parallel across the output.
- <4% deviation recovering to within 1% for 25% load change.
- Intput-output isolation figure is for isolation components only. 100% production hipot tested.
|
|
Unipower Telecom Home
Bomara Homepage